MotionBoard and bluetooth
Posted: Sat Sep 15, 2012 12:01 pm
hi,
I want to connect a sparkfun bluesmirf module to the flex motion board to use it like a rs232. The bluetooth module has 6 pin ( PWR, GND, TX-O, RX-I, CTS-i,RTS-O), I tried to connect the first 4 on the UART slot of the motion board but I can not communicate with the card. How can i fix this problem?
Thank you in advance and sorry for my english!
I want to connect a sparkfun bluesmirf module to the flex motion board to use it like a rs232. The bluetooth module has 6 pin ( PWR, GND, TX-O, RX-I, CTS-i,RTS-O), I tried to connect the first 4 on the UART slot of the motion board but I can not communicate with the card. How can i fix this problem?
Thank you in advance and sorry for my english!