Programming FLEX with the Pickit 3

[resodad]

You can use the Microchip Pickit 3 to program the FLEX board:
Starting with the Pickit pin marked with a triangle, connect as follows:
pickit pin 1 to FLEX CON 6 pin 13 (MCLR)
pickit pin 2 to FLEX CON 6 pin 58 (3V3)
pickit pin 3 to FLEX CON 6 pin 60 (GND)
pickit pin 4 to FLEX CON 6 pin 54 (PGED1)
pickit pin 5 to FLEX CON 6 pin 52 (PGEC1)
pickit pin 6 to FLEX CON 6 pin not connected
A nice alternative to ICD3 and to programming the PIC18 for USB programming.
Sketch attached.
Cheers,
John